USER GUIDE
27840HSG
1 Way Plug-In Aerial Amplifier
Introduction
This SLx plug-in aerial amplifier is designed to improve picture and sound quality by amplifying
weak UHF and VHF signals.
4G Ready - built-in filter removes interference and channel loss caused by 4G mobile phone signals.
These instructions cover the most common installation options. However, if you need further
advice, please contact our Customer Careline (see overleaf).
Please Note: If used to boost signals from the RF2 output on a satellite receiver you will need to fit a
digital bypass you will also need a TV with an analogue tuner to view the satellite signal.
Boosting the signal to your TV
ANT IN
TV
Output Input
Outdoor
Aerial
Coax Aerial Lead
(Not Supplied)
Coax Aerial Lead
(Not Supplied)
Gain Control
Boosting the signal to your Freeview ™ Box or PVR
ANT IN
Output Input
Outdoor
Aerial
Coax Aerial Lead
(Not Supplied)
Coax Aerial Lead
(Not Supplied)
Freeview™
Receiver or PVR
TV
Gain
Control
Standard installation for weak
signal areas
1. Connect the UHF aerial downlead
(typically via an aerial wall socket) to the
INPUT
socket of the SLx amplifier.
2. Connect an aerial flylead from the
OUTPUT
socket of the SLx amplifier to
the aerial input (usually marked “ANT IN”)
on the back of your TV.
Standard installation for weak
signal areas
1. Connect the UHF aerial downlead
(typically via an aerial wall socket) to the
INPUT
socket of the SLx amplifier.
2. Connect an aerial flylead from the
OUTPUT
socket of the SLx amplifier to
the aerial input (usually marked “ANT IN”)
on the back of your Freeview™ receiver
or PVR (digital recorder).
Ready
