Sleipner SH100, Руководство по установке

Страница: 2 / 36

2
2746 28 2021
-
SH 100t & 160t
Sleipner Motor AS
P.O. Box 519, Arne Svendsensgt. 6-8
N-1612 Fredrikstad, Norway
MC_0020
Contents
Products
SH100/185T-U08 - SH100 Tunnel thruster, U08
SH100/185T-U10 - SH100 Tunnel thruster, U10
SH100/185T-U11 - SH100 Tunnel thruster, U11
SH160/215T-U08 - SH160 Tunnel thruster, U08
SH160/215T-U11 - SH160 Tunnel thruster, U11
SH160/215T-U14 - SH160 Tunnel thruster, U14
SH160/215T-U06 - SH160 Tunnel thruster, U06
SH160/215T-U10 - SH160 Tunnel thruster, U10
SH100/185T-U06 - SH100 Tunnel thruster, U06
MC_0425
General Installation Considerations and Precautions for Thrusters
• Do not install the thruster in a position where you need to cut a stiffener/ stringer/ support that may jeopardise the hull integrity without checking
with the boat builder this can be done safely.
• We advise painting the gear house and propellers with anti-fouling. (NB: Do not paint the anodes, sealing, rubber fi ttings or propeller shafts)
• Do not fi nish the inside of the tunnel with a layer of gel-coat/ topcoat or similar. There is only room for a thin coat of primer and two layers of anti-
fouling between the tunnel and the props.
• Never run the thruster out of water.
• The electro/ hydrulic motor must be handled with care. Do not place down the motor on the drive shaft.
MC_0105
Considerations and Precautions for S-Link Systems
When installing an S-Link™ system DO NOT connect any other control equipment directly to the S-Link™ bus except original Sleipner S-Link™ products.
In case of connecting third-party equipment, it must always be connected through a Sleipner-supplied interface product.
Any attempt to directly control or connect into the S-Link™ control system without a designated and approved interface will render all warranties and
responsibilities of all of the connected Sleipner products.
If you are interfacing the S-Link™ bus by agreement with Sleipner through a designated Sleipner supplied interface, you are still required to install at
least one original Sleipner control panel to enable efficient troubleshooting if necessary.
Installation Manual
Responsibility of the Installer ...................................................................................................................................................................3
Thruster Measurements ....................................................................................................................................................................... 4
Thruster Specifications ........................................................................................................................................................................... 5
Technical Specifications .................................................................................................................................................................. 5 - 6
Technical Requirements / Hydraulic Hose Connections To Motor ........................................................................................................... 7
Positioning of the tunnel / thruster .......................................................................................................................................................... 8
Tunnel Length ......................................................................................................................................................................................... 9
Tunnel installation in sail boats ............................................................................................................................................................. 10
Water Deflection ................................................................................................................................................................................... 11
Tunnel ends .......................................................................................................................................................................................... 12
Tunnel installation ........................................................................................................................................................................... 13- 14
Stern tunnel installation ........................................................................................................................................................................ 15
Gear Leg & Motor Bracket Installation.................................................................................................................................................. 16
Propeller Installation ............................................................................................................................................................................. 17
S-Link System Description ....................................................................................................................................................................19
Control Panel Installation ..................................................................................................................................................................... 20
Pre-delivery Checklist .......................................................................................................................................................................... 21
Service and Support........................................................................................................................................................................... 22
Product Spare Parts and Additional Resources .............................................................................................................................. 22
Warranty Statement ............................................................................................................................................................................ 22