Slee MTR, Руководство по эксплуатации

Страница: 8 / 12

8 Manual_MTR_2021-10-011.00_EN.docx
7.2 MOUNTING THE COOLING BLOCK ON THE SLED MICROTOME
The MTR cooling block with screwed on insulation element is already pre-assembled. It can be positioned centrally
in the standard clamp. To ensure a permanently secure connection, the knurled screw should be hand-tightened
with a 17 mm open-end wrench. Samples can now be frozen on the top of the structured surface. In order to
be able to use the MTR in the optimum cutting range with the Cuttec S, different intermediate plates according
to need must be mounted.
Your device is now ready for operation and should look as shown above.
7.3 STANDARD ACCESSORIES MOUNTING MTR ON SLED MICROTOME
Description Item no.
Pillar 37185030
Intermediate plate Cuttec S - Blade holder - 5 mm 45170001
Intermediate plate Cuttec S - Blade holder - 10 mm 45170002
Intermediate plate Cuttec S - Blade holder - 30 mm 45170005
Cylinder screw ISO 4762 - M8 x 35 - A2 70010835
Cylinder screw ISO 4762 - M8 x 40 - A2 70010840
Cylinder screw ISO 4762 - M8 x 45 - A2 70010845
Cylinder screw ISO 4762 - M8 x 60 - A2 70010860
i
Please be sure to note the following combinations of intermediate plate and screws:
5 mm plate: 35 mm length of the screw
10 mm plate: 40 mm length of the screw
5 mm + 10 mm plate: 45 mm length of the screw
30 mm plate: 60 mm length of the screw
Non-observance can lead to collateral damage to the device!
Position of
intermediate
plate
Pillar
Cooling block