18
has idled to a critical temperature, the snowmobiles ECM will shut
down the engine. If this happens within the one-minute window of
any remote start activation, ENGINE DAMAGE CAN OCCUR, as
SledStart will attempt to restart engine during that first one minute.
Please use caution and only use remote start modes on a cold en-
gine!
Feature 2 - Timer Mode Interval
This feature sets the interval between Timer Mode starts. Option settings
are 1 = every hour, 2 = every two hours, and 3 = every three hours. To
activate Timer Mode, press "T". The
icon will appear on LCD
screen and the snowmobile will start and run its first cycle. To deactivate
Timer Mode, press "T" again and the
icon will disappear from the
LCD screen canceling Timer Mode. Timer Mode will run for a total of 24
hours. Option 1 = 24 cycles, 2 = 12 cycles, and 3 = 8 cycles. Engine run
time will be determined by the option selected in Feature 1.
See chart on
page 17.
Feature 3 - Turbo Mode Run Time/Valet Mode
This feature will allow cool down for turbo units or can be used as a valet
mode. To activate Turbo Mode, press
twice. To deactivate Turbo Mode,
press
twice again. Wait five seconds for
icon to expire from
LCD screen. To use Turbo Mode, with engine running and key in the run
position, apply hand brake and remove key from snowmobile. Engine will
shut off when selected time expires. Option 1 = 30 seconds, 2 = 1 minute,
and 3 = 3 minutes -
see chart on page 17
.
Note:
RPM cutoff is active during Turbo Mode but brake cutoff is not.
For Valet Mode, insert the key back into the ignition before the timer ex-
pires and turn to run position. (Do not turn to start position as starter dam-
age could occur) Apply the hand brake - now Turbo Mode is deactivated
and snowmobile can be driven again.
Feature 4 - RPM Cutoff
This feature will adjust the RPM Cutoff. This feature should be left on Op-
tion 1 (Low). Option 2 is for later use.
