Skyworth FILTOUCH WI-FI, Инструкция по использованию и установке

Страница: 31 / 41

2
8
Operation Instruction
6(7
Timer Setting
There are two modes available for the wired controller, "Countdown Timer" and "Scheduled
Timer", which can be set as below:
Whether the system is on or off, press and hold the " " button for 5 seconds, the
temperature display area of the wired controller will display the searchable parameter code
"F00". Then, press the " " button for another 5 seconds and you will be directed to the
parameter setting interface and the temperature display area will show a flashing "A01".
Press the "▲" or "▼" button to switch to "A15" and then press the " " button to enter
the setting interface. In this case, "A15" will not flash any more while the parameter value
flashes. You can press the
"▲" or "▼" button to change the parameter: "00" indicates
"Countdown Timer" and "01" indicates "Scheduled Timer". Finally, press the " " button to
complete your setting.
$'' 5
&+(&.
6(7 6(7
Press and hold the " "
button for 5 s Econds to enter
parameter search mode.
Press and hold the " "
button for another 5 seconds to
enter parameter setting mode.
Press the "▲" or "▼" button
to switch to "A15" timer
mode setting.
Press the " " button to
save your settings and exit.
Press the "▲" or "▼" button
to select the timer mode.
00 indicates Countdown Timer.
01 indicates Scheduled Timer.
Press the " " button to
enter timer mode selection.
6(7
6(7