DVI-300 Installation Manual
Document Rev. 01.004
DOC0456
Page 17 of 31
Restricted Proprietary and Confidential Information
3.4 DVI-300 COMPONENT WEIGHTS
The following table provides the weight for the DVI-300.
Table 9
— Component Weights
COMPONENT
WEIGHT
DVI-300
0.27kg (0.6 lbs)
3.5 UNPACKING AND INSPECTING THE SYSTEM COMPONENTS
1.
Check the items in the shipment against those listed on the shipping invoice to ensure that all items have
been received. If any items are missing, contact SKYTRAC Client Services.
2.
Carefully remove each item from its individual packaging.
3.
Inspect each item for damage that may have been incurred during shipping. In case it is necessary to
submit a damage claim, save the shipping container to help verify the claim.
4.
After all items have been unpacked, it is suggested that you save the containers and packaging materials
in case it becomes necessary to reship an item.
5.
Verify and record the serial number of the DVI-300. This information is required when contacting
SKYTRAC Systems to activate the satellite communications services.
3.5.1
PRODUCT MOUNTING
To operate as part of the CDU-300, the DVI-300 has to be mounted right below CDP-300. If the DVI-300 is
mounted already, disconnect the connector for DVI-300 and remove the DVI-300 from the aircraft DZUS rails.
Place the CDP-300 over the DVI-300 and secure them together using CDU-300 Mounting Brackets on both sides.
Connect the wiring harness to the rear of the CDP-300 and DVI-300. Be sure to install all connector mounting
hardware required. Mount the CDP-300 and DVI-300 to the aircraft DZUS rails using the DZUS fasteners on
them.
UNCONTROLLED COPY IF PRINTED
