![Skytrac 105-300-01 Скачать руководство пользователя страница 16](http://html1.mh-extra.com/html/skytrac/105-300-01/105-300-01_installation-manual_1291743016.webp)
DVI-300 Installation Manual
Document Rev. 01.004
DOC0456
Page 16 of 31
Restricted Proprietary and Confidential Information
3 MECHANICAL INSTALLATION
3.1 GENERAL
This section contains procedures for the mechanical installation of the DVI-300. Included are unpacking
instructions, a table listing the weight of each component, and instructions for completing the physical installation
of the DVI-300.
3.2 INSTALLATION LIMITATIONS
The following installation regulations must be adhered to:
When installing the DVI-300 the installer must have a working knowledge of aircraft electronics installation, and be
a holder of either an FAA Repairman’s Certificate or a Transport Canada equivalent. All installations should meet
the requirements of FAA advisory circular AC43.13-1B.
3.3 MAIN INSTALLATION TASKS
The main tasks for this installation are listed below:
1.
Unpack and inspect the system components. Check the contents of the installation kit against the parts
list on the Installation Kit Package and verify that all components are included and were not damaged
during shipping.
2.
Product Mounting. Determine the approximate location of the DVI-300.
3.
Install and secure the DVI-300.
4.
Configure the DVI-300.
5.
Test the DVI-300.
IMPORTANT NOTICE
All system interconnect cables must be connected before power is applied to the system.
UNCONTROLLED COPY IF PRINTED