INSTALLATION AND OPERATION INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO
NOT ATTEMPT TO INSTALL OR OPERATE
Model: 5310P
INTRODUCTION
MODE
BATTERY
COMPARTMENT
BACK
FRONT
SET
PROG
PROG MODE
SET
TRANSMITTER
The transmitter operates on (4) AAA 1.5V batteries that are included.
Install the batteries supplied with the unit into the battery compartment. It
is recommended that ALKALINE batteries always be used for this product.
Be sure the batteries are installed with the (+) and (-) ends facing the
correct direction.
When you start up the remote, if a low battery signal appears or if they
LCD screen does not illuminate when you touch it, check battery position
and if the batteries are fully charged.
REV. 1-20-14 Page 1
Skytech: 5310P
Fig. 1
T
his SKYTECH remote control system was developed to provide a safe, reliable, and user-friendly remote control system
for gas heating appliances. The system can be operated thermostatically, manually or with the built-in factory program
inside the transmitter. The built-in program has two segments, a weekdays and a weekend segment. The factory presets
are time periods for each day. SEE PROGRAM SEQUENCE BELOW. Custom programming may be achieved after the
initial setup has been performed.
This system operates on radio frequencies (RF) within a 20-foot range using non-directional signals. The system
operates one of 1,048,576 security codes that are programmed into the transmitter at the factory; the remote receiver’s
code must be matched to that of the transmitter prior to initial use.
Built-in Factory Programs
Weekdays
- Mon. Tues. Wed.Thurs. Fri.
Program 1 (P1)
5:00AM
9:00
AM
Program 2 (P2)
4:00
PM
10:00
PM
72°
MORN
DAY
72°
Weekends
- Sat. Sun.
Program 1 (P1)
6:00AM
10:00
AM
Program 2 (P2)
5:00
PM
10:00
PM
72°
MORN
DAY
72°
Table 1: Factory Programs
