Model: 1410 T/LCD-A
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION
INSTRUCTIONS DO NOT ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
This remote control system was developed to provide a safe, reliable and user-friendly remote control system for gas heating products.
TRANSMITTER
ON
TIMER
OFF
BUTTON
WALL CLIP
SLOT
FRONT
BACK
OFF
SET
ON
BUTTON
TIMER
BUTTON
SET
BUTTON
ROOM
TEMP
BATTERY
COMPARTMENT
KEY SETTINGS
1.
ON
- - -
2.
OFF
- -
3.
TIMER
4.
SET
- -
Turns appliance on.
Turns appliance off.
Changes unit from manual mode to timer mode.
Adjusts timer setting.
ON
TIMER
OFF
SET
1
2
3
4
LCD - LIQUID CRYSTAL DISPLAY
1. Display - - - - - - - - - -
2. Fahrenheit or Celsius
3. Flame - - - - - - - - - - -
4. Room - - - - - - - - - - -
5. Temperature - - - - - -
6. Set - - - - - - - - - - - - -
Indicates current room temperature.
Indicates degrees Fahrenheit or Celsius.
Indicates appliance is ON.
Indicates remote is in THERMO mode.
Appears during manual operation.
Appears
when
adjusting
the
desired timer setting.
TEMP
ROOM
SETTING ºFAHRENHEIT / ºCELSIUS SCALE
The factory setting for temperature is ºF. To change the displayed
temperature scale, press the
ON
and
OFF
keys at the same time.
Follow this same procedure to return to ºF.
TEMP
ROOM
TEMP
ROOM
MANUAL FUNCTION
ON OPERATION:
Press the ON button to turn the
appliance
ON
. (The flame icon
will appear on the LCD screen.)
OFF OPERATION
:
Press the OFF button to turn
the appliance
OFF
. (The flame
icon will disappear from the LCD
screen.)
•
Press the
ON
button to start the
appliance.
•
Press the
TIMER
button. The
LCD screen will show the word
set.
•
Press the
SET
button until
the desired time is reached
(15min - 180min in 15 minute
increments). The max setting
time is 3 hours.
•
NOTE: The LCD display will
flash the set time for 6 seconds,
then start the countdown.
•
Press the
OFF
button to turn off
the timer, and the appliance.
TIMER FUNCTION
SET
ON MODE
OFF MODE
SET MODE
COUNT DOWN MODE
The transmitter operates on (2) 1.5V AAA batteries. It is recommended that ALKALINE
batteries always be used for this product.
Be sure the batteries are installed with the (+)
and (-) ends facing the correct direction, and are fully charged.
REV. 11-8-16 Page 1
TEMPERATURE UPDATING FEATURE
This remote control has a temperature updating feature built into its software. The transmitter reads
the room temperature every 2 minutes, then updates the room temperature on the LCD screen.
Skytech 1410 T/LCD-A
