Skytec STM-3012, Руководство пользователя, Страница: 2 / 12

GB
Congratulations to the purchase of our mixer .
Please read the manual thoroughly prior to using the unit.
WARNINGS:
•
Read the manual prior to using the unit.
•
Keep the manual so that any other user can read it
first.
•
Keep the packaging so that you can transport the unit
in its original packaging in order to avoid damage
•
For indoor use only.
•
Prior to the first use, have the unit checked by a
qualified person
•
The unit contains voltage carrying parts. DO NOT
open the housing.
•
When you unplug the unit from the mains always pull
the plug, never the lead.
•
Do not plug/unplug the unit with wet hands.
•
If the plug and/or lead are damaged, they need to be
replaced by a technician.
•
If the unit is damaged to an extent that internal parts
are visible, DO NOT connect the unit to the mains
and DO NOT switch it on. Contact your dealer.
•
Repairs should only be carried out by a technician.
•
Connect the unit only to an earthed 220-240Vac/50Hz
mains outlet protected by a 10-16A fuse.
•
Do not place the unit near heat sources such as
radiators, etc.
•
During a thunderstorm or if the unit will not be used
for a longer period of time, unplug it from the mains.
•
If the unit has not been used for an extended period
of time, condensation may occur inside the unit. Let
the unit reach room temperature first.
•
To avoid accidents in public premises, you need to
adhere to the applicable rules and follow the
indications/instructions.
•
Keep out of the reach of children.
•
Do not use cleaning sprays to clean the slider controls.
They leave residues that cause dust and smear
deposits inside the controls. In case of malfunction,
ask a qualified technician for advice.
•
Make sure that all channel slider controls and the
master volume control are set to the minimum prior
to switching the unit on.
•
Handle the channel faders with care. Quick variations
can damage the speakers as the amplifier might clip.
•
Avoid clipping of the amplifier. This happens if the
clip Led’s, mostly mounted on the front panel of the
amplifier light up. Set the volume to a sufficiently
low level.
•
Make sure that the mains voltage is switched off
before you make connections or changes.
•
Use the appropriate connection leads for the specific
signals.
•
Always switch on the amplifier at latest and switch it
off at first. This prevents damage to your equipment
in case of overdrive.
•
Repairs must always be carried out by an agreed
technical service.
•
Avoid excessive mechanical charges of the parts. If
the LED vu-meter is continuously in the red area, the
output signal is too strong. This results in distortion.
Lower the master volume to an acceptable level in
order to prevent damage to your equipment further to
overdriving.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to
the unit. This would also invalid your warranty. The warranty is not applicable in case of accidents or damages
caused by inappropriate use or disrespect of the warnings contained in this manual. Tronios BV cannot be
held responsible for personal injuries caused by a disrespect of the safety recommendations and warnings.
This is also applicable to all damages in whatever form.