E_MH_Mounting_instructions_Skylux_Climaglide_10mm_carrier_system
10/09/2021
14/16
Sliding elements (CGPL)
The carrier profiles are custom-made and fitted with wheel guidance and locks. In the single system with one lock,
there is one carrier profile fitted with a lock opening. It’s used for the sliding element on the parking side. There is
also another carrier profile with locking side which goes to side profile with sliding lock.
Installing the sliding elements
Lay the glass plate horizontally on 2 trestles. Provide protection against scratches. Take the rubber strip and cut
it 1 cm longer than the width of the glass. Position this on the face side of the glass plate. Take the carrier profile
and remove at least one end piece or lock piece. Coat the carrier profile on the inside with a detergent solution.
Position the top of the carrier profile over the rubber and make sure the side of the carrier profile is aligned with
the side of the glass plate. First, push the carrier profile manually on the glass as far as possible. Tap the carrier
profile into the glass plate with a rubber hammer (we recommend 700 gr) until only the edge of the rubber
remains visible. Measure the squareness of the glass against the profile with a try square. The surplus rubber
protruding at the sides must be cut off. Remount the end pieces and/or lock pieces.
In case of single system, there are end pieces CGPLS10 on each carrier profile on both sides, except on the carrier
profile which is locked by the sliding lock – this profile has a shorter end piece (CGPLSS10) on the locking side and
a standard end piece.
In case of double system, there are two locks (CGPLL10), one on both carrier profiles. On the opposite sides and
other carrier profiles, there are end pieces (CGPLS10). On the rest of carrier profiles, there are two end pieces
(CGPLS10).
glass
rubber
carrier profile
lock opening left
lock opening right
CGPLS10
CGPLL10
CGPLS10
carrier – locking side
CGPLSS10
