Wireless Flash Light
Model : WF-SD1-CH
1. INTRODUCTION
The wireless flash light is a transceiver and designed to monitor the signal from the Skylink dialer
model SD-001. When it receives the signal from the dialer, it will flash the light.
2. LEARN THE DIALER TO THE WIRELESS FLASH LIGHT
1) Press the ‘Learn’ button on the flash light unit for 3 seconds as enter to select this
programming mode.
2) You will now see the SYS green light flashing quickly. Activate the dialer to send a signal to the
Wireless Flash Light unit.
3) Once it learned the dialer successful, The SYS LED stop flashing. Now you can activate the
wireless flash light.
3. LEARN WIRELESS FLASH LIGHT UNIT TO DIALER MODEL SD-001
Once the dialer is in programming mode, the green LED will flash one at a time that means you
can now add remote controls or sensors to the dialer.
1) Press red button when the green LED is flashing one at a time, as Enter to select this
programming mode (Add Remote Controls / Sensors).
2) You will now see both red and green flash one at a time. The red LED now represents you
have entered the “Add Remote Controls / Sensors” programming mode. The green LED
represents the location you want to add the new remote controls or sensors. There are 4 different
locations, 1, 2, 3, or 4.
3) To select location 4, press red button as “Enter” when the green LED is flashing once.
4) Once the location is selected, the dialer will emit 3 beeps indicating you can now press the
‘Learn’ button on the wireless flash light unit to activate.
Note: If you press green button again to skip, you will quit from programming.
4. OPERATION
When the dialer is activated, this will activate the “learned” wireless flash light unit.
5. LOW BATTERY INDICATION
When the wireless flash light unit is being low battery level, it will send signal to activate the
‘Learned’ dialer.
6. BATTERY
The wireless flash light operates on 4.8-volt rechargeable battery or DC adapter. This battery
does not need to be replaced if used under normal condition.
7. WARRANTY
If, within one year from date of purchase, this product should become defective (except battery),
due to faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of
purchase is required.
8. FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
