Skylab M&C Technology Co., Ltd
Bluetooth Module User Manual Module
No.:SKB360_369_501_EVB
6 / 7
SKB360_SKB369_KB501_-DA-001,A/1
bank of lights
Used for I/O port debugging, low effiective
9
3.3V
电源
Power:3.3V
方便给外部提供电源
3.3V power supply for external modules
10
5V
电源
Power:5V
方便给外部提供电源
5.0V power supply for external modules
11
按键
Button
自定义按键，当
12
部分的跳帽左右连接时有效
Customized button when part 12 is connected with jumper from
left to right
12
GPIO
和按键输出脚
GPIO and button output
pin
跳帽左右连接时
11
中的按键才有效
When the pins is connected with jumper from left to right
13
UART
到模块接口
UART interface with
module
UART
和模块引脚口接口，默认跳帽左右连接
Conneting interface for UART and module pins. Default jump
from left to right
14
复位按键
reset button
按键复位
,
低有效
Reset, low effective
15
USB
接口
Usb interface
USB
串口接口
USB to UART interface
16
DC
头
Power interface
外部
5V
电源接口
,
仅当评估板外挂大功率外设时使用
DC 5V power supply interface. Only used when the EVB
connecting external equimpment which consumpt large power
from the EVB
17
DB9
接口
DB9 interface
RS232
串口接口
UART RS232 interface
3 EVB
驱动安装
EVB drive installation
将
Micro USB
数据线 USB 端接到电脑上，另一端接到 EVB 上，打开设备管理器，查看是否有对应的 com 口出现，参
照图二；如果没有则需在电脑安装串口驱动，
PL2303_Prolific_DriverInstaller_v1210.exe
。
Connect the USB end of the Micro USB data cable to the computer and the other end to the EVB, and open the
device manager to see if there is a corresponding com port, refer to Figure 2; If not, you need to install a serial
port driver on your computer, pl2303 _ prolific _ driverinstaller _ v1210.exe.
