Skyjack ZB12032, Руководство по эксплуатации

Страница: 42 / 73

TM
Page 44 December 2007
ZB12032
Section 2 - Operation Start Operation
2.9 Start Operation
Carefully read and completely understand the Operating
Manual and all warnings and instruction labels
(refer to labels section) on the telehandler.
wARNiNG
DO NOT operate this telehandler without
proper authorization and training. Failure
to avoid this hazard could result in death
or serious injury.
Before operating this telehandler, perform the following
steps:
1. Visual and daily maintenance inspections
(see
Section 2.7 ).
2. Function tests (see Section 2.8 ).
3. Jobsite inspection
It is the responsibility of the operator to perform
a jobsite inspection and avoid the following
hazardous situations:
holes or drop-offs •
ditches or soft fills •
floor obstructions, bumps or debris •
overhead obstructions •
electrical cords, hoses and high voltage •
conductors
hazardous locations
•
inadequate surface support to withstand all •
load forces imposed by the telehandler
wind and weather conditions
•
the presence of unauthorized personnel •
other possible unsafe conditions •
wARNiNG
An operator should not use any telehandler
that:
does not appear to be working properly. •
has been damaged or appears to have worn or •
missing parts.
has alterations or modifications not approved by
•
the manufacturer.
has safety devices which have been altered or
•
disabled.
has been tagged or locked out for non-use or
•
repair.
Failure to avoid these hazards could
result in death or serious injury.
2.9-1 Starting the Engine
wARNiNG
Ensure that you maintain three points of
contact to mount/dismount the cab.
1. Enter cab and close door (if equipped).
2. Sit in the driver’s seat and fasten seat belt.
wARNiNG
Always wear seat belt when operating the
telehandler.
3. Ensure parking brake is on and gear selector in
neutral position.
4. To start the engine, turn the ignition switch to
on position. The “wait to start” message will be
displayed on the electronic dash display. Once
“wait to start” message is no longer displayed;
turn the key to start position.
5. Allow engine to idle for 30 seconds until low brake
pressure light is off.