Skyjack 7127, Руководство по эксплуатации

Страница: 15 / 85

SKYJACK, Page 16
February 2008
Mid Size & Full Size RT’s
Engine Powered
Section 2 - Operation Component Identification
2.5 Component Identification
The following descriptions are for identification,
explanation and locating purposes only.
2.5-1 Emergency Main Power Disconnect
Switch
This switch is located at the side of the hydraulic/
electrical compartment.
1
Figure 2-1. Emergency Main Power Disconnect Switch
Emergency Main Power Disconnect Switch 1.
- This switch, when in off position, disconnects
power to all circuits. Switch must be in on position
to operate any circuit. Turn switch off when
transporting aerial platform.
2.5-2 Motion Alarm
The alarm produces an audible sound when any control
function is selected. On aerial platforms with certain
options, a flashing amber light will accompany this
alarm.
2.5-3 Tilt Alarm
The aerial platform is equipped with a device which
senses when the aerial platform is out of level in any
direction. When activated, it disables drive and lift
functions of the aerial platform and an alarm produces
an audible sound accompanied by the amber light. If
the alarm sounds, lower the platform completely, then
reposition aerial platform so that it is level before raising
the platform.
NOTE
If the tilt alarm sounds and the platform does
not, or only partially raises, immediately
lower the platform completely and ensure
that the aerial platform is on a firm
level
surface.
2.5-4 Base Control Console
This control console is located in the hydraulic/electrical
compartment. It contains the following controls:
1
4
4
3
2
Figure 2-2. Electrical Panel
Hourmeter 1. - This gauge records accumulated
operating time of engine.
Platform Raise Pushbutton 2. - This pushbutton
controls “ ” raising of platform.
Platform Lower Pushbutton 3. - This pushbutton
controls “ ” lowering of platform.
Circuit Breakers 4. - In the event of a power overload
or positive circuit grounding, the circuit breaker
pops out. Push breaker back in to reset.