Skyjack 6826El, Руководство по эксплуатации

Страница: 25 / 47

SKYJACK, Page 25
April 2006
SJIII Series E - CONVENTIONALS
Start Operation Section 2 - Operation
Warning
An operator should not use any aerial platform
that:
• does not appear to be working properly.
• has been damaged or appears to have worn
or missing parts.
• has alterations or modifications not approved
by the manufacturer.
• has safety devices which have been altered
or disabled.
Failure to avoid these hazards could result in
death or serious injury.
2.5-3 To Raise the Platform using the Base
Controls
Warning
Be aware of overhead obstructions or other possible
hazards around the machine when lifting.
Warning
Ensure that you maintain three points of contact
when using the ladder to mount/dismount
the platform.
1. Use the ladder of the aerial platform to access
the aerial platform deck.
2. Close the gate/chain.
3. Select “BASE” position with BASE/OFF/
PLATFORM select key switch.
4. Ensure the emergency stop button is pulled out.
5. Dismount the platform using the ladder.
6. Turn the emergency main power disconnect
switch to “ON” position.
7. On the base controls, press and hold the enable
switch.
7. Raise the platform by selecting “
× ×
× ×
×
” (UP) with
platform UP/DOWN toggle switch from the base
controls.
2.5-4 To Lower the Platform using the Base
Controls
1. On the base controls, press and hold the enable
switch.
2. Lower the platform by selecting “
Ø
” (DOWN) with
platform UP/DOWN toggle switch from the base
controls.
2.5-5 To Raise the Platform using the Operator’s
Control Box
1. Turn the emergency main power disconnect
switch to “ON” position.
Warning
Ensure that you maintain three points of contact
when using the ladder to mount/dismount
the platform.
2. Use the ladder of the aerial platform to access
the aerial platform deck.
3. Close the gate/chain.
Warning
Be aware of overhead obstructions or other possible
hazards around the machine when lifting.
4. Ensure the emergency stop button is pulled out.
5. Select “PLATFORM” position with BASE/OFF/
PLATFORM select key switch.
6. Select “LIFT” position with LIFT/OFF/DRIVE
select toggle switch.
7. Activate and hold the enable trigger switch by
squeezing it towards the proportional controller.