In diagram form:
4. HOUSING
The housing is formed from an aluminium alloy, painted black. It is considered to be protected from
ingress to IP65. On no account should it be subjected to immersion.
The housing provides screening to the amplifiers and the screening of the lid is maintained by a
connected wire. This should not be disconnected, and care should be taken whilst removing the cover that
the wire is not inadvertently tugged out of its place.
Dimensions of the amplifier unit are approx.: 85mm x 81mm x 36mm (LxWxH).
Cables enter the housing via 5 cable glands located on two sides of the housing unit. Sensor cable
glands have not been specifically designated.
Please ensure that all cable glands are tightened finger tight onto each cable. This provides
protection from ingress, and provides cable retention/fastening.
6
1 – 4 Channel External Amplifier
