SkyAzúl Greer MG514, Инструкция по установке, калибровке и обслуживанию

Страница: 30 / 90

27
2.6.6 Menu 05 - Swing Potentiometer (If Equipped)
This menu is used to enter the zero point and the swing direction of the swing potentiometer (if
equipped). The swing potentiometer is located in the collector ring assembly under the hydraulic swivel.
The job of the potentiometer is to track the movement of the upper half of the crane all the way around
the swing circle. This function can only be zeroed in the stowed, or house lock positions, and the
numbers should count up, when rotating to the right or in a clockwise direction. If no swing
potentiometer is present, calibration is not required.
1. Press the Next or Prev b utton until “05 Swing Potentiometer” appears in the information window
at the right.
2. Press the 05 Swing Potentiometer button to enter the routine.
3. Stow the boom in “road travel” mode. Press the Zero = ---- button.
4. The swing is now zeroed.
5. Next, raise
the boom out of the rest and rotate to the right. The number by “Zero = 0” should
increase.
a. If not, press the Next button and then press Direction = button and the “+” will change
to a “ - ” and the direction will be reversed.
6. Press the Next button to view the Remove Swing pot command. Use this command to remove
the swing pot if the crane is equipped with swing switches. It may be used as a troubleshooting
tool and is not part of the calibration routine.
7. Press the Exit button to return to the main menu.
TEST
SET
TEST
SET
TEST
SET
SkyAzúl, Equipment Solutions www.skyazul.com 301-371-6126