4O3A Signature – Antenna Genius User Manual
Page
15
of
55
Use a Cat5e, Cat6 or Cat6a UTP cable (not supplied, please don’t use a cheap cable here; poor-
quality high-speed data cables are never a good idea!) between the Ethernet port on your AG
and your station LAN switch or hub (switches preferred over hubs). This should be the same
place where your FLEX-6000 Signature Series radio connects to your LAN. Note this LAN
connection can be as simple as a port on a DSL router or as fancy as a standalone Gigabit switch.
AG can be controlled by PCs connected over WiFi to your LAN as long as AG itself is connected
directly to your LAN via a wired connection to an Ethernet switch or hub (switch recommended;
Ethernet hubs will slow down your LAN).
8.7.
DIP Switch configurations
DIP 1 and DIP 2 set PORT A (which will typically be connected to Flex ANT1 or Radio A in non-
Flex installations):
DIP 1
DIP 2
CONTROL MODE
OFF
OFF
LAN control -
FlexRadio
OFF
ON
BCD control
ON
OFF
Pin-to-Port control
ON
ON
Genius Series Device
DIP 3 and DIP 4 set PORT B (which will typically be connected to Flex ANT2 or Radio B in non-
Flex installations)
DIP 3
DIP 4
CONTROL MODE
OFF
OFF
LAN control -
FlexRadio
OFF
ON
BCD control
ON
OFF
Pin-to-Port control
ON
ON
Genius Series Device
If you want to stack more than one AG into single system, you need to assign unique ID
numbers. You can use DIP5 and DIP6 to achieve this. For more info see chapters
DIP 5
DIP 6
NETWORK ID