SKS-Kinkel Elektronik GmbH
EN
300097 Basic additional speaker
Support-Hotline: +49 (0) 2661-98088-112
- 5 -
Version: 1.0
E-Mail: [email protected]
Document art. no. 97010500
Remount the additional speaker in the upper part of the supporting
frame.
Subsequently press the additional speaker into the frame until it clicks
into place.
5.3
Surface mounting
Using the screws attach the supporting frame of the 300098 BUS bell
to the wall. Please use the fastening holes provided on the supporting
frame.
Pay particular attention to the installation cable when mounting
the supporting frame!
Connect the terminals to the previously installed cable. The terminals
are located at the back of the additional speaker.
The pre-assembled cables are then connected to the additional
speaker.
To avoid errors when connecting cables please use the planning
guide or the wiring diagram.
Remount the additional speaker in the upper part of the supporting
frame.
Subsequently press the additional speaker into the frame until it clicks
into place.
