DOL 634 CE
52
Technical User Guide
Backup
Create a backup copy of the controller data. Among other things data comprises
settings, pages, historical data, house name, IP address, calibration values, etc.
Restore
Restore data on the controller from the backup. Among other things data comprises
settings, pages, historical data, house name, IP address, calibration values, etc.
Daily backup
Activate backup of the controller data every night at 01:30.
Format SD card
Format USB stick
Erases all data from the SD card or USB stick.
SD card status
USB stick status
See the status of the SD card or USB stick.
SKOV A/S recommends that you always save the setup on a USB stick before updating a program.
13.4 Software update
Important information
Loading a new program usually takes up to two minutes.
During the update, the power supply must not be interrupted and the USB stick must not
be removed before the software update has completely finished, i.e. before the graphic
user interface is accessible and usable again.
We advise against updating software when there are animals in the house.
During the update, all relays are released, e.g. to the shutter motors. The ventilation system will
thus be open, and all other functions will disconnect.
Should it be necessary to update the software while there are animals in the house, the update
should be carried out in the presence of an animal expert and observing the following precaution:
• Evaluate which climate climate functions are to be run in manual mode during the update, and
activate the manual switch for each of them to ensure that these conditions are maintained
during the software update.
• Remove the power supply (230 V and battery) from the emergency opening, if the air inlet and
air outlet should remain closed during updating.
CAN Protocol will remain unchanged after a software update. See also the Circuit Diagrams and
Cable Plans document.
13.4.1 Preparing for a software update
1. Note or take pictures of the pages.
2. Note or take pictures of current configuration under the menu
Show connections
(software updates from old
to new software will reallocate individual inputs or outputs in some instances).
3. Note or take pictures of the management and climate values that are described in the chart below.
If there are animals in the house, it is very important to note the values that are described in the chart: (*If in-
stalled).
Menu
Function
Setpoint
Management
Batch day no.
Number of set animals
Climate
Temperature setpoint
Heater temperature setpoint*
Humidity setpoint*
