Tightening torques
Bracket/clutch pedal to front wall
1)
Master cylinder to front wall
1)
1)
Replace self-locking nut.
1.10
Removing and installing the bracket with
the master cylinder (Rapid 2011 ►)
Special tools and workshop equipment required
♦ Closing tool - T10249-
1.10.1
Removing
– Lay a cloth under the master cylinder.
– Using an extraction bottle extract as much brake fluid as pos‐
sible from the brake fluid reservoir.
– Detach return hose -A- at master cylinder and close with a
suitable tool e.g. closing tool - T10249/1- .
Note
♦
Do not use the hose clamp - MP7-602- , otherwise the return
hose -A- will be damaged.
♦
During the following work, ensure that no brake fluid lands on
longitudinal member or gearbox. If this is the case, these
points must be cleaned thoroughly.
– Remove the locking clip -B- on the master cylinder up to the
stop.
– Release and cut the tube-hose line -C- out of the master cyl‐
inder.
Note
When performing work in the footwell, put cloths on the carpet to
protect it from possible brake fluid spills.
– Removing the footwell vent ⇒ Heating and Air Conditioning;
Rep. gr. 87 .
– Put steering wheel in the highest position.
– Unplug connector from the clutch pedal switch - F36- .
– Unscrew the top fixing nut -arrow- for the bracket. To do so,
position an long extension on the nut in the opening between
the dash panel -2- and the bottom steering column trim panel
-3-.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
41
