Ski-Doo REV-XR 2009, Руководство оператора

Страница: 105 / 151

MAINTENANCE PROCEDURES
Start the engine and accelerate slightly
so that track barely turns. This must be
done in a short period of time (about 5
seconds).
Check that the track is well centered;
equal distance on both sides between
edges of track guides and slider shoes.
A01F05A
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
If off center, perform alignment as fol-
lows:
WARNING
Remove the tether cord cap (DESS
key) before performing any main-
tenance or adjustment, unless oth-
erwise specified. Vehicle must be
parked in a safe place, away from
the trail.
1. Remove the tether cord cap (DESS
key).
2. Loosen rear idler wheel retaining
bolts.
3. Tighten the adjustment bolt on side
where the slider shoe is the far-
thest from the track insert guides.
A01F0BA
1 2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
4. Tighten retaining bolts.
WARNING
Properly tighten wheel retaining
bolts, otherwise wheel may come
off and cause track to “lock”.
mmo2008-003-047_b
TYPICAL
1. Retighten to 48 N•m (35 lbf•ft)
5. Restart engine and rotate track
slowly to recheck alignment.
6. Reposition snowmobile on ground.
7. Install rear wheel caps if so
equipped.
Suspension
Rear Suspension Condition
Visually inspect all suspension compo-
nents including slider shoes, springs,
wheels, etc.
______________
103