Ski-Doo FORMULA S 1997, Руководство по ремонту

Страница: 106 / 926

Section 03 ENGINE
Sub-Section 08 (REWIND STARTER)
03-08-4
CAUTION : The use of standard multi-pur-
pose grease could result in rewind starter
malfunction.
To install a new rope no. 6 : insert rope into
sheave no. 5 orifice and lock it with the key no. 7
as illustrated.
1. Push to lock
To adjust rope tension :
Wind rope on sheave and place rope sheave into
starter housing making sure that the sheave hub
notch engages in the rewind spring hook.
Rotate the sheave counterclockwise until rope
end is accessible through starter housing orifice.
Pull the rope out of the starter housing and tem-
porarily make a knot to hold it. One turn preload
will give 7 turns of tension when fully extended.
Position pawl no. 8 , pawl lock no. 9 and circlip
no. 10 .
Install locking spring no. 11 and lubricate with
MOLYKOTE G-n paste from Dow Corning
®
or
equivalent.
1. Spring coated with MOLYKOTE G-n paste
Install locking ring.
CAUTION : This lubricant must NOT be
used on rewind springs as it does not stay
on when dry.
INSTALLATION
On fan cooled models with oil injection pump, re-
install oil pump on rewind starter assembly.
Reinstall rewind starter assembly on engine.
Thread starter rope no. 6 through rope guide
when applicable.
-
A01C15A
1
A01C0CA
A01C17A
1
-
A03C0VA