SKF SMD 1B, Руководство по жизненному циклу компонентов, Страница: 44 / 114

Page 44
EN
1. Safety instructions
1. Safety instructions
The operator of the described product
must ensure that the assembly instruc-
tions are read and understood by all
persons assigned with the assembly,
operation, maintenance, and repair of
the product. The assembly instructions
must be kept ready to hand.
Note that the assembly instructions
form part of the product and must
accompany the product if sold to a new
owner.
In addition to the assembly instructions,
general statutory regulations and other
regulations for accident prevention
and environmental protection must be
observed and applied. 1.2 Authorized personnel
Only qualified technical personnel may install,
operate, maintain, and repair the products de-
scribed in the assembly instructions. Qualified
technical personnel are persons who have
been trained, assigned and instructed by the
operator of the final product into which the de-
scribed product is incorporated. Such persons
are familiar with the relevant standards, rules,
accident prevention regulations, and assembly
conditions as a result of their training, experi-
ence, and instruction. They are authorized to
identify and perform necessary actions while
avoiding any risks which may arise.
The definition of qualified personnel and the
prohibition against employing non-qualified
personnel are laid down in DIN VDE 0105 and
IEC 364.
The described product is manufactured in
accordance with the generally accepted rules
and standards of industry practice and with
occupational safety and accident prevention
regulations. Risks may, however, arise from its
usage and may result in physical harm to
persons or damage to other material assets.
Therefore the product may only be used in
proper technical condition and in observance
of the assembly instructions. In particular, any
malfunctions which may affect safety must be
remedied immediately.
1.1 Intended use
Floe meters of SKF´s SMD series are designed
for:
the usage in centralized lubrication
systems in assets and machines
They can be used with mineral oils and
environmentally tolerable oils from aworking
viscosity of 50 mm
2 /S to 650 mm 2 /s.
Any other usage is deemend non-complint
with the intended use.