SKF PowerLuber 1882E, Инструкция по эксплуатации и обслуживанию, Страница: 7 / 24

Residual risks
Additional residual risks may arise when
using the tool which may not be included in
the enclosed safety warnings These risks
can arise from misuse, prolonged use etc
Even with the application of the relevant
safety regulations and the implementation
of safety devices, certain residual risks can
not be avoided
These include:
• Injuries caused by touching any rotating/
moving parts
• Injuries caused when changing any parts,
accessories
• Injuries caused by prolonged use of a tool
When using any tool for prolonged periods
ensure you take regular breaks
• Impairment of hearing
• Health hazards caused by breathing dust
developed when using your tool (example:
-working with wood, especially oak, beech
and MDF )
Vibration
The declared vibration emission values
stated in the technical data and the declara-
tion of conformity have been measured in
accordance with a standard test method
provided by EN 62841* and may be used for
comparing one tool with another The
declared vibration emission value may also
be used in a preliminary assessment of
exposure
When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly
using power tools in employment, an
estimation of vibration exposure should
consider, the actual conditions of use and the
way the tool is used, including taking account
of all parts of the operating cycle suchsuch
as the times when the tool is switched off
and when it is running idle in addition to the
trigger time

WARNING
Do not use any hose that has not been
approved by SKF Extreme pressure may
cause nozzle extension or whip hose to burst
Replace hose at first sign of wear, kinks, or
damage to outside jacket
Follow whip hose instructions and
warnings
Failure to comply may result in death or
serious injury

DANGER
Grease gun can develop high pressure up to
10 000 psi
(689 bar) Use safety glasses and
gloves for protection during operation Keep
hands clear of exposed rubber portion of
hose
Failure to comply will result in death or
serious injury
NOTE
Vibration emission value during actual use of
power tool can differ from declared value
depending on ways tool is used Vibration
level may increase above level stated
Labels on
battery charger*
The following symbols are shown on tool:
Time-lag miniature
fuze link, 3.15A
IEC
IEEE/ANSI
IEEE/ANSI
Specific safety
PowerLuber can generate up to 10 000 psi
(689 bar) Use only Lincoln 1218, 1224, 1230
or 1236 outlet whip hoses Grease injection
injuries are very serious injury Hold hose
only in area of spring guard
• Avoid accidental start
• Be sure switch is not depressed when
inserting battery pack
• Replace hose at first sign of wear, kink or
damage to outside jacket
• Do not bend hose so it
becomes kinked
• Do not overreach Keep proper footing and
balance at all times Proper footing and
balance enable better control of tool in
unexpected situations
• Use safety equipment Always wear eye
protection Dust mask, non-skid safety
shoes, hard hat or hearing protection must
be used for appropriate conditions
• Do not use gun near open flame or other
fire hazards
• Do not ingest lubricants
• Gun uses lubricants that may be
flammable Greases are often marketed as
high temperature because gun must
maintain lubricating properties in hot
areas, but lubricants may be flammable if
temperature is too high
• Read all warnings on lubricants before
using gun
* Indicates change

C AUTION*
Do not stare into light beam
Failure to comply may lead to light
personal injury
7