SKF Multilog On-Line System IMx-M
1 - 1
User Manual
1
Introduction
Important Messages
The following messages are important information that require special care in order to
have a safe and reliable IMx-M system.
Important messages, instructions and information in this manual must be
followed carefully. Otherwise, harm might occur to equipment and/or personnel.
IMx-M shall be used for speed alarming only. It shall not be used to protect/trip
machine on overspeed. IMx-M does not fulfill the requirements related to
overspeed protection.
All safety critical decisions must be driven by the data from the protection
module.
Always use relay outputs for the safety/danger triggering.
Use @ptitude Observer only for monitoring purposes.
Use 4-20 mA outputs only for monitoring purposes.
Use Modbus data only for monitoring purposes.
Note: Be sure to always monitor the circuit fault status (circuit fault relay).
In order to ensure a safe system, installation, configuration and maintenance
of the system must be done by trained personnel only.
An IMx-M rack/cabinet contains circuit boards that are static sensitive.
Therefore, appropriate precautions must be used to prevent electrostatic discharge
(ESD) when handling circuit boards, refer
Each module must be placed correctly in the designated slot. The designated
slot of the each module is shown in
section.