Plug-in Vision Series Art Light Manual
of
1
2
4527 Arnold Ave., Naples, FL 34104 • 1-800-561-0492 • www.situlighting.com
Operating Instructions:
Power On/Off and Changing Modes:
• All features of your new Vision Series will be accessed through the
included remote control.
• To turn your light on/off, press the red button on the top left of your
remote control.
• This light has 64 levels of variable light output that can be selected
via the “Bright –“ and “” buttons on the remote control.
Alternatively, there are shortcuts on the remote control for 100%,
80%, 60%, 40%, 20%, and 10% outputs.
• Remote control is powered by a CR2032 battery. Battery life is
typically 1 – 2 years. Your Vision Series will not function properly
and may not turn on or off when battery needs replacement.
Installation Instructions:
Tools required: Screwdriver, drill (optional for wall mount), hammer (optional), pencil, level, and tape.
Body Adjustment:
• Once mounted, the body of the light can be pivoted to better align
the light output to your artwork.
• We recommend adjusting the body of the fixture so that the beam of
light begins at the top of your artwork (not the frame).
SEE REVERSE SIDE FOR OTHER MOUNTING OPTION
Mounting to Artwork
1. Remove artwork from wall.
2. Locate then mark top center of artwork with pencil
3. Locate the Vision Series Mounting Template provided which fits
your model (17”, 30”, or 43”). If needed, fold or cut the mounting
template to your selected size.
4. Tape the selected template to the back of artwork with the
centerline matched to the center mark on your artwork. Ideally, the
long horizontal line showing with the indicated screw holes should
be
½
” – 1” below the top of your frame. With a sharp object or
pencil mark the four mounting block holes.
5. Align the mounting block with the marked holes and attach with 4
small black screws provided. Take care that once the screw is
installed it will not damage the artwork. Do not worry if mounting
blocks are not completely level. Adjustments in step 6 can make up
for slight differences.
6. Unfold the arms of the Vision Series 90˚. Do not tighten or attempt
to tighten the arms. Guide the two arms into the slots of the
mounting bracket and tighten with the included allen wrench.
Height of the light is subjective and should be adjusted as desired.
Raising the light can help eliminate glare.
7. Connect the included power supply to the DC jack attached to the
light. An extension cord is included. Use if needed.
8. Use remote control to dim as desired. Reattach artwork to wall and
enjoy!