Sitex SP38 Autopilot, Инструкция по установке и эксплуатации

Страница: 147 / 162

Sitex SP38 Installation and Operation
Document PN 29010101 V2r0
- 14 6 -
The following messages indicate a serious problem. Operation of the autopilot cannot
continue until the problem is resolved.
Message Description
NO LINK
BATTERY TOO HIGH
Battery voltage has risen above ~40 VDC.
Check all wiring and charger systems.
NO COMMAND HEAD
The main Control Head is not responding to the SPU.
Check all wiring.
FUSE F2 FAULTY
Fuse F2 on the SPU has blown. This fuse supplies
current to the drive outputs.
Check all wiring and verify that all output loads
(solenoids, pump motors, etc) are within the
specifications given for the SPU.
Replace the fuse with the same type only.
LOW BATTERY
The SP38 has detected that the battery supply
voltage is less than ~10 VDC, which is too low to
continue safe operation.
Check all wiring as well as the battery/batteries.
ROM ERROR
The SP38 has detected a problem in its program
memory. Return the unit to your Sitex Dealer for repair.
RFU NOT FOUND
The SP38 cannot detect the presence of a Rudder
Follower Unit.
Check all RFU wiring. If no faults are found, the RFU
may be defective.
Contact your Sitex Dealer for repair advice or
replacement.
DATABASE ERROR
The SP38 has detected a problem in its program
memory after software update due to incompatibility.
Contact Sitex for advice.
Table 1 0 – Critical Error Messages
Appendices
The current SP38 controller is not paired or
connected to the SPU in the system. check
connections, Terminators. Go into main menu for
system config. function.