Sirona teneo, Руководство по эксплуатации

Страница: 90 / 200

61 93 556 D3509
D3509
.
201.01.02
.
02 19.09.2008
90
Sirona Dental Systems GmbH
4 Operation
Operating Instructions TENEO
Dentist element
Preselecting NaCl rinsing, setting the flow rate, and activating the rinse function
Preselecting NaCl rinsing, setting the flow rate, and activating the rinse
function
The NaCl rinsing function can be used to activate an NaCl jet to rinse the
treatment area whenever the burr instrument is not running.
Preselect NaCl rinsing key
A setting can be made to show or hide the NaCl Rinsing key in the
Implantology program . If the show function is selected, the NaCl , NaCl
Rinsing and CCW Rotation keys are all displayed adjacent to one other. The
implantology steps can be run through only in a forward loop.
9
The Implantology sub-screen is displayed on the touchscreen.
¾
Touch the Preselect NaCl rinsing key.
ª
If the key is highlighted orange, the NaCl rinsing keys are shown in
the sub-screen and the NaCl rinsing is displayed in the Implantology
program .
Setting the flow rate for NaCl rinsing The flow rate of the peristaltic pump for NaCl rinsing can be set separately.
9
The Preselect NaCl rinsing key is marked orange in the sub-screen. The
setting keys for the NaCl rinsing are now displayed.
¾
Use the – and + keys to set the flow rate for NaCl rinsing.
Activating NaCl rinsing via button on
foot control
9
The NaCl rinsing key is displayed in the Implantology program .
¾
Press the right button of the foot control.
ª
The NaCl rinsing function remains active as long as the key is
pressed.
Switching the torque signal on/off
Switching the torque signal on/off
This can be used to set the acoustic signal that sounds whenever 75% of the
currently set torque value is exceeded.
¾
Touch the Acoustic Signal key.
ª
If the key is highlighted orange, the torque acoustic signal is
activated.
Setting the foot control as a direct starter or speed foot control
Setting the foot control as a direct starter or speed foot control
The foot control can be set as a direct starter (key highlighted gray) or as a
speed (key highlighted orange) foot control.
For details, see "Setting the foot control as a direct starter or speed foot
control" [
66]
.
Setting the number of work steps
Setting the number of work steps
The number of implantology treatment work steps, e.g. predrilling, final
drilling, tapping, etc. can be set. Up to eight work steps can be preset.
S
0
0