59 62 134 D 3407
82
D 3407
.
208.01.10
.
02 07.2009
3 Operation
Sirona Dental Systems GmbH
Image acquisition
Operator’s Manual SIDEXIS XG
or
➢ Use the
"[I]mage"
menu bar to select the
"[3]D-Scan"
menu item.
Operation with several 3D X-ray units
If several X-ray units are installed and networked in a practice, then an X-ray
acquisition unit must be selected before taking a 3D X-ray exposure. The
selection is made by clicking the desired unit in the
"Status / Name"
column
and it is highlighted by a blue bar.
Selection dialog box
Acquisition units marked with a question mark are possibly not switched on.
Acquisition units which are crossed out are possibly busy.
After the X-ray acquisition unit has been selected, further dialog boxes show
how the connection between the acquisition unit and the calling computer is
established. These dialog boxes can provide important information in case of
connection errors.
Image acquisition
As soon as the message
"Waiting for X-ray"
appears, the X-ray unit is enabled
by the computer. You can now release the exposure at the unit.
After further messages the following dialog box which informs you about the
progress of the data transfer operation finally appears. Note that the
"Quit"
button is now unavailable for safety reasons.
Different X-ray exposures are automatically recognized and differentiated by
the system.
As long as SIDEXIS is busy with taking an X-ray exposure, a green indicator
flashes as a warning in the acquisition dialog box.
Readiness for exposure ends when you press the
"Quit"
or the [Esc] key.
Once the exposure has been started, it can only be stopped via the
GALILEOS.
CAUTION
If no such ready dialog box appears, or the indicator in the dialog box does
not flash, it is not possible to release radiation on the GALILEOS until the
problem has been rectified.
