Sirocco SCENIC Edge, Инструкция по установке и эксплуатации

Страница: 15 / 38

15
With the fire box in place and the burner tray removed fix the gather hood into place where
required by lifting into position through the fire box opening securing in place with self-
tapping screws supplied, to ensure air tight seal you can seal with aluminium gas tap (not
supplied).
Whilst the opening is ready for installation of the fire, the gas supply can be routed as
required and connected to the isolation tap via the 8mm compression fitting.
Note: In no circumstance should you use soft soldered connections to or
underneath the burner tray.
The isolator tap or restrictor elbow must be fitted to the incoming supply to facilitate
servicing.
The gas pipe must be suitably protected where it passes through fireplace openings. Any
sleeving should be sealed to the pipe at its ends.
The open end of the gas supply pipe should be temporarily sealed to prevent ingress of dust
and dirt during installation.
Note: DO NOT install or use the appliance without this seal in place.
Failure to fit this seal correctly will cause the flue suction to act upon the
area under the burner tray resulting in poor performance, and overheating of
this area.
You can now decide where to route your gas pipe,
knock out holes are provided in the rear and side of
the fire box for use where concealed pipe work is
required.
Knock out the holes with a screwdriver and a sharp tap
from a hammer and fit the rubber grommet supplied.