Sirocco SCENIC Edge, Инструкция по установке и эксплуатации

Страница: 14 / 38

14
Remove front grill and then lift the burner tray free.
SECTION 7.1: PREPARING THE OPENING
Before installing the fire, check the flue for correct operation using a smoke pellet, all of the
smoke should be drawn up the flue and exit correctly from the terminal.
If problems are found DO NOT fit the fire until corrective measures have been completed.
Before running the gas supply into the opening, offer up the fire box to the fireplace to check
the fit is good.
Ensure that it slides in correctly, the sealing face sits flat and square to the wall and that the
base is level
At this stage it is essential to ensure that the gather hood outlet of the fire is not obstructed
in any way.
The gather hood is an integral component for the correct function of the appliance and will
invalidate the warranty if the gather hood is not fitted.
Remove the fire box and apply the self adhesive sealing strips around the edge of the rear of
the firebox frame, approximately 5mm in from the edge.
Mark and drill the fire frame in the relevant points on the wall place rawplugs in place.
Push the appliance back into the opening, centralise and securing in to place with the screws
provided.
Note: Fibre Rawlplugs might be preferred rather than plastic Rawlplugs as the heat
from the fire might affect their performance.