20
pH
Fig. n°46
6.2.2 - Cleaning the blade, the blade cover and
the ring
WARNING: a pair of metallic gloves must be
worn while cleaning the bla-de (1) (Fig. n°
47) .and a damp cloth must be used.
Unscrew the hand grips from the blade cover (1),
(2) and extract the blade cover (3) using the
proper grip to hold it (
Fig. n°47
)
.
At this point it is
possible to clean the blade (
Fig. n°48)
.
To clean the surfaces opposite the blade and
the ring, the blade must be extracted in the
following way:
1.unhook the blade cover (
Fig. n°47
);
2.
3.
take out the sharpening device (
Fig.
n°49
ref.a
) and open, by using the
graduated
handgrip, the thickness
gauge enough to
make the jig (
Fig. n°48 ref.b
) stick to the blade;
unscrew the three or four screws i
(
Fig. n°
49 ref.f
), depending on the
model, which
fasten the blade;
4.
rest the jig (b) on the blade, so that
the split in
the jig fits in the ring (
Fig.
n°49 ref.c
);
5.
match the axes of the two holes (
Fig.
n°49 ref.d)
on the blade with the two-knobs(Fig. n°49 ref.e)
on the jig, simply making the blade turn to the
desired position;
Fig. n°47
Fig. n°48
Fig. n°49
a
d
f
b
e
c
3
2
1
-
bring the trolley (2) to the end of its
run (
a
)
from the controls side; partially
unscrew the
plate lock handgrip (3),
pull the trolley towards
the operator;
completely unscrew the plate
lock
handgrip and tilting the trolley (b -
Fig.
n°
45
);
-
having taken off the trolley, the goods
holder
plate can be carefully cleaned
with warm
water, the equipped
detergent or neutral
detergent (pH 7)
Fig. n°46.
