SIP 06434, Инструкция по эксплуатации и техническому обслуживанию

Страница: 7 / 21

7
6 Use
Before usage of the device, check the incoming cable, handle and the handle cable to assure that
they are not damaged.
1. Disconnect the device from the electric network and loosen the screws on the handle.
2. Insert the working coil into the holes in the clamping holder of the coils (handle, 2) and
tighten the locking screws on the sides.
3. Connect the supply cable of the device into a properly grounded standard socket ~230V,
50/60Hz and turn on the device using the main switch. Before turning on, make sure that the
handle is laid in a safe place and that the heating button is not pressed down.
4. Attach or put the working coil on the material you want to warm up and press the button on
the handle. Heating remains activated during the pressing of the button - do not exceed the
operating cycle of 2 minutes of heating and 2 minutes of cooling.
5. After finishing the cycle, release the button on the handle and remove the heating coil from
the heated material.
NOTE: During heating there should be a gap of around 3-5mm between the coil and
the heated material to avoid excessive wear of the heating coil. A gap larger than 3-
5mm decreases heating efficiency and extends the heating time.
After finishing heating, place the handle with the heating coil in a safe, inflammable
place until the heating coil is completely cooled. Then turn off the device using the
main switch and disconnect it from the electric network.
ATTENTION: The coil and the heated object can reach a high temperature and/or
cause burns or result in fire.
6.1 Detachable coils
FRONT ATTACHABLE COILS
The standard supplied
diameters of front
attachable coils are
15-45mm