Sinterit LISA PRO User Manual | 6
IMPORTANT!
•
The product should be placed on a flat, stable surface that extends beyond all edges of the
product.
•
If you place the product by the wall, the distance between the product and the wall should be
greater than 50 [cm] / 20 [in].
•
We suggest using the Sinterit Platform. Its dimensions are adapted to the requirements of the
Sinterit Lisa PRO printer.
•
The product will not work properly if it is set at an angle.
STOP!
Do not place or store the printer:
•
outdoors;
•
near water, or heat sources;
•
in areas with large amounts of dust;
•
in places subject to shocks, vibrations, high temperature and/or humidity;
•
extreme changes in temperature and humidity;
•
near inflammable and volatile substances, concentrated acids or corrosive vapours;
•
in places easily accessible to children and animals.
STOP!
•
The printer emits large amounts of heat (60 [°C] / 140 [°F]), and therefore it is
prohibited to place it on the wood or wooden furniture.
•
Never use wood, equipment with wooden elements and flammable substances
while working with the printer.
•
The min. distance between the printer and wooden parts is 50 [cm] / 20 [in].
STOP!
•
The printer must not be operated in a corrosive or explosive environment.
•
Avoid using the device close to open flames or sources of heat.
•
Do not disconnect while the circuit is live or unless the area is free of ignitable
concentrations.
•
Do not connect or disconnect when energized.
B. GENERAL SAFETY RULES
WARNING!
•
Only trained and qualified personnel should install, replace or service the equipment.
•
The device should be installed in accordance with these instructions and by trained personnel.
WARNING!
•
Only adults should use the printer.
•
When using the machine, mind other people, especially children.
ATTENTION!
•
Risk of crushing upper limbs while closing the printer Lid.
•
Never place hands between the Lid and Print Chamber while closing.
•
Do not put your hands in the Service area of the BEDs when the BEDs are
running (in case of a removed Removeable Front Panel).
•
Be aware when removing and installing the lid from the Nitrogen chamber and
Overflow Bin.
•
Do not remove the Removeable Front Panel during printer operation.