Sinterit LISA PRO User Manual | 48
ATTENTION!
•
Before starting any work with powder, always wear adequate protective clothing,
eyewear, face mask, and gloves.
•
A suitable set is included in the DEDICATED POWDER TOOLS for Lisa PRO printer as
PERSONAL PROTECTION kit.
A. REFRESHING THE POWDER USING THE PHS DEVICE
NEW PRINTING POWDER
= ADDING FRESH POWDER TO THE USED ONE + MIXING
STEP ONE - ADDING FRESH POWDER TO THE USED POWDER FROM PRINTER
1. Prepare a portion of Fresh Powder according to the information provided on the printer screen or in the Sinterit
Studio report.
2.
When the sifting process is finished, remove the Metal container from the PHS device with the used, sifted powder
(remember to insert a new, empty container).
3. Add Fresh Powder to the Used Powder in the Metal container. Close tightly using the lid and clamping ring.
4. Shake the container for at minimum 15 seconds so that both powders are pre-mixed. We will have a Pre-Print Ready
Powder, which should be mixed in the PHS.
5. Before opening the container, wait a while for the powder to settle.
PRE-
READY
POWDER
1. Connect powders.
3. Shake the container vigorously.
2. Close with lid
and clamping ring.
4. Pre-print ready powder
which should be mixed in PHS
USED POWDER,
SIFTED BY PHS
FRESH POWDER
Connecting the powders.
STEP TWO - MIXING OF POWDER (HOMOGENISATION)
To ensure that both types of powders mix thoroughly (both in the first and second method), we recommend sieving them
2-3 times to obtain a homogeneous blend.
1. Take out from Drawer 3 and place the Funnel on the Metal container. Remember to put a clamping ring between the
Funnel and the Metal Container.
2.
Turn on the vacuum cleaner (from „0” to „1”). Vacuum Suction sensor indicator should light up.
3. Press the ON/OFF Sifting button to turn on the Sifting Module and the Powder Feeding Screw.
4. On the Control panel, in the SUCTION section, the LED above the DEPOWDERING ZONE should be activated.
5. Gently pour the entire content of the Metal container onto the Powder Chamber grid. Remember not to pour the
powder on the grid of the Fine Dust Chamber - there must be access to the air!
6. After emptying the Powder Chamber and sifting the powder, remove the Metal container from the Sifting module
and put a new one in its place.
7. To ensure homogeneous mixing of the powders, repeat steps 1-6 at least once more.
8.
The newly created powder (Print Ready Powder) is mixed and ready to use in the Sinterit Lisa/Lisa PRO printer.
