Sinoboom GTTZ10EJ, Руководство по эксплуатации

Страница: 25 / 88

SAFETY
GTTZ10EJ Operation Manual 3-7 © Nov. 2020
FALL HAZARDS
• Each person on the platform must
wear harnesses or use safety
equipment consistent with
government regulations. Fasten
the cable to the fixed point of the
platform. Never fasten the cable of
more than one person to a fixed
point on the platform.
• Do not sit, stand or crawl on the
guardrails. When on the platform
always remain standing on the
platform floor.
• Do not enter or exit the platform
through the mast/boom.
• Keep the platform floor free of
obstacles.
• Do not allow mud, oil stains,
grease or other slippery
substances reside on the
footwear or platform floor.
• Do not enter or exit the platform
unless the machine is fully in
stowed position.
• Close the platform entry door
before operating the machine.
• Do not operate the machine if the
handrails are not properly
installed and the platform entry
door is not closed.
COLLISION HAZARDS
At a minimum, operators must operate and maintain the
machine as stated in this manual and in the
Maintenance Manual in addition to following more
stringent industry regulations and workplace rules.
COLLISION HAZARDS
• Pay attention to the field of sight
and the presence of blind spots
when moving or operating the
machine.
• The non-staff must maintain a
minimum of 2m (6.6ft) distance
from the machine while it is
travelling or swinging.
• When the work platform of a
moving machine is approx2m
(6.6ft) away from the
obstructions, use the boom lift
function (rather than the drive
function) to get close to the
obstructions.
• Switch to the low speed gear
before parking the machine that
drives at high speed.
• Do not use the high speed gear
when the machine is driving
reverse or in restricted or
enclosed work area.
• Check the work area to avoid
ground and overhead
obstructions or other possible
risks.
• Be sure to exercise caution when
using the platform and ground
controls. Color-marked
directional arrows show the
function of travel, lift and
steering.
• Users must comply with user,
workplace and government rules
regarding the use of personal
protective equipment (hard hats,
safety belts and gloves, etc.).
• Place the machine on level
ground or in a secured position
before releasing the brakes.
• Only lower the platform when
there are no people or
obstructions in the area beneath
it.
• When the machine is conducting
aerial work, warn the staff/non-
staff not to work, stand or walk
under the raised boom or
platform.
• Limit the speed of travel
according to ground conditions,
crowding, gradients, the presence