Sinoboom AB14EJ, Руководство по эксплуатации

Страница: 83 / 94

GTZZ14EJ&16EJ Operation Manual 10-1 © Aug 2020
10
MAINTENANCE
This section provides detailed procedures for regular
maintenance inspections.
UNSAFE OPERATION HAZARD
Failure to follow the proper
maintenance may result in death,
serious injury or damage to the
machine.
Follow these general rules:
• Maintenance inspection shall be completed by a
person trained and qualified on the maintenance of
the machine.
• Routine maintenance inspection contains the
maintenance items to be performed daily for normal
machine operation. The maintenance personnel
must perform the routine maintenance inspection
and complete the report in details.
• Scheduled maintenance inspection shall be
completed quarterly, half-yearly, and annually. The
maintenanace personnel must perform the
scheduled maintenance inspection and complete
the report in details.
• Timely tag and remove from service a damaged or
malfunctioning machine.
Repair any machine damage or malfunction before
operating machine.
• Keep all inspection records for at least 10 years or
until the machine has been removed from service or
as required by the machine owner/company/keeper.
• Machines that have been out of service for a period
longer than 3 months must complete the quarterly
inspection.
• The replacement parts used in the maintenance
should be identical or equivalent to the original
parts.
• Unless otherwise specified, perform the
maintenance procedures according the following
terms and conditions:
– Park the machine on flat, level and solid ground.
– Place the machine in non-oprating position.
– Turn the key switch on ground controller to OFF
position and remove the key to prevent
unauthorized use of the machine.
– Pull out the red emergency stop buttons on
ground and platform controllers to OFF position
to avoid unintended start-up of the operating
system.
– Turn off the main power switch,
– Disconnect all DC power from the machine.
– Lock all wheels to prevent movement of the
machine.
– Before releasing or removing the hydraulic
components, release the hydraulic oil pressure
in the hydraulic circuit, particularly with the
counterbalance valve on the cylinder.
CONDUCTING A PRE-
DELIVERY INSPECTION
When the machine owner/company changes, in
addition to conducting a pre-delivery inspection, the
corresponding inspection shall be carried out according
to the maintenance schedule requirement and repair &
inspection report. When conducting a pre-delivery
inspection, comply with the following requirements:
1. It is the responsibility of the machine owner/
company to perform a pre-delivery inspection.
2. Follow this procedure each time before delivery.
Performing a pre-delivery inspection could reveal
potential problems with the machine before you
begin putting the machine into service.
3. Never use a damaged or malfunctioning machine.
Tag the machine and do not use it.
4. Only professionally trained, qualified personnel may
repair the machine and must follow the procedures
as stated in
operation manual and maintenance
manual .
5. A competent operator must conduct daily
maintenance on this machine as stated in
operation
manual and maintenance manual .
Before delivering the machine, complete the following
record using these instructions:
1. Prepare the machine before delivery, which
includes performing a pre-delivery inspection,
following maintenance procedures and performing
functional inspections.
2. Use the following table to note the results. After
each section is complete, mark the appropriate box.