Sinoboom 1530SE, Руководство по эксплуатации

Страница: 50 / 90

© Jun 2020 7-4 GTJZ0408SE&0608SE&0408ME&0608ME Operation Manual
OPERATING THE MACHINE
UNSAFE OPERATION HAZARD
When using the platform railings, un-
fold them in the opposite manner in
which you first folded them. Use the
wire rope safety pins when unfolding
the railings at each side to help en-
sure accurate installation.
OPERATING WITH THE
PLATFORM CONTROLLER
ON THE GROUND
Before operating the machine with the platform control-
ler on the ground:
1. Keep a safe distance between the operator, ma-
chine and fixed platform.
2. Pay attention to the traveling direction of the ma-
chine when using the controller.
DRIVING ON A SLOPE
Before driving on a slope:
1. Determine the climbing ability of the machine.
GTJZ0408SE&0608SE: 25% (14°)
GTJZ0408ME&0608ME: 25% (14°)
2. Ensure the platform is fully folded.
3. Ensure that the slope where you plan to drive is less
than the angle of the machine’s climbing ability.
NOTICE
Climbing ability refers to the maximum permissible
percentage of the slope when the machine is on solid
ground with sufficient traction and the platform is car-
rying only one person. As the weight of the machine’s
platform increases, the machine’s climbing capacity
reduces.
To determine the slope:
1. Use a carpenter’s rule, a straight board (longer than
1 m [3.3 ft]), and a tape measure.
Figure 7-2
2. Measure the height and length/distance of the
slope.
3. The slope measurement consists of the numbers
for the height and length/distance x 100%.
NOTICE
To avoid the wheel from dangling, the machine
should not be driven for more than 2 minutes on
slopes with the maximum climbing capacity allowed,
and be sure that the temperature of the motor shell
does not exceed 70
℃ .
USING THE BATTERY
LEVEL INDICATOR
Use the diagnostic reading display on the platform
to determine the battery level.
Table 7-2
PLATFORM POWER DISPLAY POWER RATIO DESCRIPTION
90-100%
The battery has been fully charged.
70%
The battery is at 70% of its capacity.