SINO SDS 2-3VA, Руководство по эксплуатации

Страница: 34 / 53

29
Press in sequence.
7. Input the processing direction
Press in sequence.
8. The interface of “Proc” is displayed.
Press or to switch over between the numbers of the processing
points.
Move the machine tool to the position where 0 is displayed in both the X
window and Y window.
Punching can be started at that point.
9. After the processing is completed, press to return to the normal
display status.
5.3 Oblique plane (slope) processing
When an oblique plane of relatively large
slant angle is to be processed, it is the most easy
and simple to use the function of oblique plane
processing.
I. Oblique plane calibration:
When processing the spare part as shown in
Figure (a) in the XY plane, before processing
the oblique plane, calibrate the slant angle of
the work piece first. At this time, the function of
oblique plane processing plays the role of
calibrating the oblique plane.
Steps for calibrating oblique planes:
First of all, put the work piece on the
workbench,
approximately according to the required slant angle.