|
Spectre 3.0 Elite Kit Installation Manual
Revision 1.0
Page
| 3
Installing Radiators
To install the radiators the Distribution Plate section(s) of the Spectre 3.0 Elite Kit(s) must be
removed by undoing the x6 fasteners across the top and bottom. Then the radiator(s) can be
installed. Position the radiator/s correctly to align with the ports on the main Spectre 3.0
Distribution Plate, this can be done with the adjustment on the Spectre 3.0 Elite(s). Once the
radiator/s are in place reinstall the Spectre 3.0 Distribution Plate(s).
LED Strip Installation
Note:
Version 1.0 does not come with the LED
Shroud included, this is something which will need
to be purchased separately by contacting us at
Spectre 3.0 Elite is only compatible with maximum
2mm high and 5mm wide LED strips. LED strip
length can be up to 435mm.
For Version 1.1 and onwards remove the LED Shroud
by undoing the two fasteners marked diagram 1.
Check the LED Strip length against the length of the
LED Strip mounting position which is marked in
diagram 2. Cut the LED Strip to length then install it
into the LED strip position. Make sure to select
which side you want to run the cable to depending
on how you plan the cable management in your
build.
Dimensions & Flow
Note
The flow can be run in
either direction.
Содержание Spectre III Elite
Страница 1: ...vv Revision 1 0 ...
