Singer XL-580, Инструкция по эксплуатации

Страница: 130 / 140

124
‡
When embroidering larger or heavier pieces of fabric,
it is helpful to support the fabric on a table in front and
back of the machine.
‡ :KHQZRUNLQJZLWKVSHFLDOW\WKUHDGVVXFKDVPHWDOOLF
WKUHDGV RU GHVLJQV ZLWK GHQVH VWLWFK DUHDV LW LV
recommended that you lower the embroidery speed.
‡
Be sure to deactivate the Thread Cutter Mode when
doing endless embroidery. This will help eliminate the
possibility of the thread coming out of the needle when
sewing the alignment stitches and long jump stitches.
‡
To change a bobbin during embroidery, raise the
needle by turning the handwheel toward you. Raise the
presser foot lifter. Remove the hoop from the machine
with the fabric remaining in the hoop. Remove the
bobbin cover plate and empty bobbin. Wind the bobbin,
insert it into the bobbin case and replace the bobbin
cover plate. Place the hoop back onto the machine.
Lower the presser foot lifter. Press the
Start/Stop
button to resume embroidery.
‡ 6KRXOG \RX ILQG WKDW WKH KRRS ZLOO QRW UHOHDVH IURP
the machine because the back of the foot is coming
in contact with the endless hoop clamp, use Reverse/
)RUZDUG6WLWFKEXWWRQWRPRYHWRDQRWKHUDUHDWKDWZLOO
allow you to remove the hoop. When the bobbin has
EHHQ FKDQJHG XVH )RUZDUG5HYHUVH 6WLWFK EXWWRQ WR
move the needle back to position and resume sewing.
If this is not possible, due to the type of design you
are embroidering, remove the presser foot and needle
to remove the hoop from the machine. Replace the
presser foot and needle to resume embroidering.
Helpful Tips: