Sindoh 3DWOX-1, Руководство пользователя

Страница: 109 / 120

5
-7
Maintenance
5
3.2 In Cases where Filament is Cut Between the Extruder and Nozzle
1 Remove the Snap-Ring on the fitting in the nozzle and pull out the tube.
Use Extruder mode and move the filament towards the nozzle to push out the cut filament.
After removing all cut pieces of filament, insert the tube into the nozzle and attach the snap ring.
* Push the tube in until the tube under the black indicator cannot be seen.
After attaching the Snap-Ring, gentely push the tube in (Approx 1.5mm)
Use Extruder mode to transfer the filament towards the nozzle and check that filament is coming out
of the end of the nozzle to make sure it is working properly.
3.3 When Filament End is Visible Outside the Cartridge After Unloading
1 Pull out the filament approximately 50~60cm, and cut the filament. (Reference to 3.1 filament cutting tip)
2 Like the image below turn the gears and the filament will retrieve back to cartridge. Insert until filament is
invisible, reinstall the cartridge into the printer and activate LOAD.