Sinclair SCV-1400EB, Руководство по обслуживанию

Страница: 88 / 160

86
Procedure
For SCV-750EB and SCV-1400EB
P0
High pressure switch or discharge
temperature switch connection on main
PCB is loose 1
Yes
Ensure High pressure switch or discharge
temperature switch are connected properly
No
High pressure switch or discharge
temperature switch have short-circuited or
failed
2
Yes
Replace the high pressure switch or
discharge temperature switch
No
The high pressure side is blocked, caused
by crushed or bent pipe or blocked EXV 3
Yes
Inspect the system and fix the error
No
The heat exchange is poor 4
Yes
Inspect the system and fix the error
No
The water flow rate is not sufficient in
cooling mode
Yes
Inspect the water system and fix the error
No
Notes:
1. Discharge temperature switch connection is port CN27 on the main PCB(labeled 26 in Part 4, 2.2.1 Main PCB component) .High pressure switch connection
is port CN21 on the IPM inverter module PCB;
2. Measure the resistance among the three terminals of the pressure sensor. If the resistance is of the order of mega Ohms or infinite, the pressure sensor
has failed;
3. High pressure side blockage causes discharge temperature to be higher than normal, discharge pressure to be higher than normal and suction pressure to
be lower than normal;
4. In heating mode check water side heat exchanger, water piping, circulator pumps and water flow switch for dirt/blockages. In cooling mode check air side
heat exchanger, fan(s) and air outlets for dirt/blockages.
Excess refrigerant or System contains air or
nitrogen
Drain the refrigerant in the system,
vacuum with a vacuum pump, and refill
the nominal weight of refrigerant after
ensuring that the vacuum degree meets
the requirements
Replace outdoor main PCB
Yes
Replace Inverter Module PCB