Simrad TV80, Справочное руководство

Страница: 40 / 306

38
406388/B
Setting up the SR15 Receiver Unit on an Ethernet (LAN) port
The SR15 Receiver Unit allows you to receive information from the PX catch monitoring
sensors: PX MultiSensor mk2, PX MultiCatch and PX TrawlEye. The Receiver Unit must
be connected to the Processor Unit using an Ethernet line.
Prerequisites
In order to connect a catch sensor to the TV80 system, the following requirements must be
met.
• The TV80 software is installed on the Processor Unit.
• The license string for the software is installed and activated.
• One or more receivers are available for connection to the TV80.
Context
The SR15 Receiver Unit comprises a rugged box providing all necessary receiver electronics.
The receiver is designed for low noise, and it can handle input signals spanning a very large
instantaneous dynamic amplitude range. All targets are correctly measured and displayed.
The SR15 Receiver Unit allows you to connect one single hydrophone. Depending on
your fishing requirements, you may need to install more than one hydrophone to receive
the information from the catch sensors. With a single channel receiver, you must manually
switch between the hydrophones to check which hydrophone that provides the best
communication.
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3 Observe the
I/O Setup
page on the right side of the
Installation
dialog box.
4 Select
Add LAN Port
.
Observe that the
Select Input (LAN)
dialog box opens.
5 Select the SR15 Receiver Unit.
Every new interface is presented as a small "block diagram" on the
I/O Setup
page.
Result
Every interface is presented as a small "block diagram". The
I/O Setup
page also presents a
number of "inspection points". These are small circular icons with an "i".
Simrad TV80 Reference Manual