Simrad SC90, Руководство по установке

Страница: 273 / 544

419050/B
271
a Make sure that all cables leading to and from the unit have been properly
mounted and secured.
b Make sure that enough slack has been provided on each cable to allow for
maintenance and replacement.
6 Make sure that the unit has been identified with the relevant product label(s), and
that one label includes the part and serial numbers.
Result
Requirements
Results
The Processor Unit is correctly installed with easy access for maintenance
and replacement of parts.
The Processor Unit is free from scratches, dents or other physical damage.
Free access to all the connectors on the Processor Unit is provided. All
cables are properly mounted with enough slack.
The Processor Unit can be fully opened for access to the internal parts.
The Processor Unit is properly earthed.
Date and signature:
Visual inspection of the Operating Panel
A visual inspection of the Operating Panel is required to verify that the unit has not been
physically damaged during the installation..
Prerequisites
The SC90 is installed as specified in this manual. The SC90 is turned off. You need
the following equipment:
• Multimeter
Procedure
1 Make sure that the Operating Panel is installed in the correct location, and that it is
suitably oriented for easy maintenance and replacement of parts.
2 Make sure that the physical installation of the unit has been completed.
a If the unit is installed inside a rack or in a closed compartment, make sure that
ample ventilation is provided to avoid overheating.
b Make sure that ample space is provided around the unit to allow for
maintenance and replacement of parts.
c Make sure that the bolts, screws or studs holding the unit are of the correct size.
d Make sure that the correct flat and shake-proof washers have been used.
e Make sure that all nuts have been tightened properly.
Setting to work