Simrad ES120-7C - REV D, Руководство по установке, Страница: 64 / 98

62
330254/B
A
Steel conduit
B Bushing
C
Washers
D
Rubber gasket
E Packing nipple
F
Cable to echo sounder (or a
junction box)
Note
Make sure that you do not damage
the transducer cable by tightening
the packing nipple too hard.
Simrad recommends that steel
conduit’s diameter is according
to the diameter of cable gland’s
bushing. The conduit must extend
to above the vessel’s water line.
Related topics
Installing the transducer, page 21
Cable gland for wooden and GRP hulls
A bronze cable gland kit can be made for wooden and GRP vessels.
Note
Simrad takes no responsibility for the correct manufacturing, installation of cable glands,
associated hull modifications and/or structural support of transducer cable penetration.
These activities are subject to individual approval by the respective classification society
for the vessel in question.
The principle for this type of installation is shown in the illustration below:
Simrad ES120-7C Installation Manual