Simpro Ezi-MT, Руководство пользователя

Страница: 20 / 36

4. Assembly, Handling, Transport & Storage
4.1 Assembly
The Ezi-MT is usually delivered fully assembled.
4.2 Moving
When the Ezi-MT is standing upright it can be easily moved on its castor wheels, using the
grab-handle provided. To ensure stability, the cradle should be positioned approximately
100mm off the ground when moving.
An accessory is available from Simpro which enables a directional lock on the castor
wheels. This can make the machine easier to manoeuvre on sloping ground.
Extra care should be taken when moving the machine on sloping ground.
4.3 Lifting
If the Ezi-MT needs to be lifted for any reason, carry out the following procedure:
1. Check that the lifting equipment is in good condition and rated to lift at least 250kg.
2. Affix a sling or chain to the lifting lug at the top of the mast.
3. Use one person to operate the lifting equipment, and at least one other person to
hold the machine steady and watch for hazards.
4. Lift, move and lower the machine into position, ensuring it remains upright at all times.
The standard Ezi-MT weighs approximately 110kg. Never attempt to lift the machine using
equipment with insufficient lifting capacity.
Never stand or reach underneath the machine while it is being lifted.
4.4 Transportation
If the machine needs to be transported, observe the following procedure:
1. Apply both foot-brakes.
2. If possible, use lifting equipment to lie the machine onto its side on a wooden pallet,
and securely strap it into place.
3. Use a forklift to load the pallet onto the truck deck.
4. Tie the machine into position using marked tie-down points and strops rated to at
least 1000kg. Ensure it is fastened against lateral forces from any direction.