Simpro Dumpmaster, Руководство пользователя

Страница: 26 / 60

6. Open the door and remove the empty bin as per Section 4.2 .
7. Repeat from step 1) as required.
Release the RAISE or LOWER button, or press the EMERGENCY STOP button at any time to
stop the cradle.
4.3.4 VSD Control Panel
How to operate the controls of a VSD machine,
with a joystick to allow progressive control of the
cradle lifting speed.
1. Before operation, check that the machine is
stable and safe to use as per
Section 4.1 .
2. Open the door and place the full bin onto the cradle, taking care that it is properly
positioned as per
Section 4.2 , then shut the door.
3. Push the JOYSTICK FULLY FORWARD to begin lifting the bin.
4. When the bin reaches the top of the mast and starts to invert, gently move the
JOYSTICK SLIGHTLY BACK so that the material is poured from the bin in a controlled
manner, as desired . Wait for the contents of the bin to empty.
5. Pull the JOYSTICK FULLY BACK until the cradle rests on the ground.
6. Open the door and remove the empty bin as per Section 4.2 .
7. Repeat from step 1) as required.
Release the JOYSTICK to stop the cradle at any time.
4.3.5 Safety-Monitored Control Panel
How to operate a machine with an electronic
PLC control unit and a safety monitoring system
to comply with safety standards such as
ISO13849-1 and AS/NZS4024 up to PL(d)/Cat3
or higher.
Dumpmaster models that are fitted with a safety-
monitored control system may be used in either
‘Manual’ or ‘Automatic’ mode, selected using a
switch on the control panel.
The operating procedure for each mode is as follows:
4.3.5.1 Automatic mode
1. Before operation, check that the machine is stable and safe to use as per Section 4.1 .
2. Open the door. If the door is locked, press the LOWER button to unlock it.
3. Place the full bin onto the cradle, taking care that it is properly positioned as per
Section 4.2 , then shut the door.
4. Turn the mode-selector switch to AUTO.
5. Press and hold the blue RESET button for two seconds.
a. The safety system will now conduct an auto-diagnostic check. If no faults are
detected, the blue light will go out and the machine will be enabled.